Tel: +86-512-56720201
Home > News > Content
Categories
Add: Yanjiang Road,Leyu Town, Zhangjiagang, Jiagnsu, China
Tel: +86-512-56720201
Fax: +86-512-56720209
Mob: +8613776257103
Email: sansu@sansumachine.com

Maintenance And Maintenance Of Granulation Production Line

Zhangjiagang Sansu Machine Co.,Ltd | Updated: Jan 25, 2018

Some enterprises' granulating production line does not pay attention to the maintenance and operation of workers' pre job training, resulting in some large and small problems during the operation of the equipment, affecting production. Regular maintenance and maintenance of prilling production line in use is very important. Proper operation and regular maintenance of equipment can prolong the service life of the equipment for 3-5 years.

1. to maintain the cleaning of the machine for a long time; when a long time is shut down, there should be anti rust and antifouling measures for the machine.

2. the raw material is put on the gate, and no metal and other impurities are allowed to mix in the material and be mixed and extruded in the machine. In order to avoid damage of machine noise. When the machine is not produced, the hopper should be closed so as not to enter the working area of the screw.

3., the main reducer and feeding device reducer should regularly check the cleanliness of the internal oil. When the new machine runs for 50 hours, the lubricating oil must be changed. After normal production, it should be replaced if the lubricating oil is seriously polluted.

When the 4. unit is running, the lubricating transmission is lubricated at the right time.

5., in case of special situations, it will take a long time to shut down (such as power failure). We should clear up the remaining materials in time, so as to prevent the polymer from being cured after cooling and curing, and affect the next production.

6. regular cleaning units in each cooling water interface fouling (some water impurities, easy fouling) so as to avoid clogging caused by bad cooling effect or influence the precision of temperature control.

7. the electric control cabinet should be cleaned once a month so as to avoid a short circuit fault